Traphouse & Skeethouse Setup Instructions

Step-by-step guides

Traphouse Setup Instructions

ALIGNMENT & INSTALLATION

 

Traphouse Mounting Instructions

The traphouse will mount to the canvas shooting screen via magnets and a metal plate. No holes need to be made in the canvas shooting screen. There are magnets attached to the back of the traphouse and the included metal plate will be affixed to the wall behind the canvas. 

 

Attach the enclosed metal plate to the wall behind the canvas: 

Align the metal plate to the horizontal center (right to left) and 3" - 4" below the horizon on your canvas (the horizon is considered to be where the grass meets the trees). Mount the plate in this area behind the canvas. Most people mount the plate to the wall with duct tape.

 

⚠️ Tips for traphouse dismount and repair:

Use care when removing the traphouse. Slide it off parallel to the wall rather than pulling it away from canvas.

If magnets become detached over time, Gorilla Glue Gel may be used to reattach magnets to the painted surface of the traphouse (not bare styrofoam).


Skeethouse Setup Instructions

ALIGNMENT & INSTALLATION

 

Skeethouse Mounting Instructions

Each skeethouse will mount to the wall via magnets and a metal plate. No holes need to be made in the canvas shooting screen. There are magnets attached to the back of the skeethouse and the included metal plates will be affixed to the wall behind the canvas, one at each end. Most people mount the plates to the wall with duct tape. See the diagram below for skeethouse placement.

 

⚠️ Tips for skeethouse dismount and repair:

Use care when removing the skeethouses. Slide them off parallel to the wall rather than pulling them away from the canvas.

If magnets become detached over time, Gorilla Glue Gel may be used to reattach magnets to the painted surface of the skeethouse (not bare styrofoam).

 

Skeethouse Metal Placement: