Gun Assembly

Training with your own gun makes all the difference.

DryFire USA offers four different Gun Assemblies.

Mechanical Switch Gun Assembly: This gun assembly comes in four pieces.

• A barrel anchor (you choose the gauge, 12, 20, or 28 gauge)
• A gun laser mounted in an aluminum holder
• A black electronics box, which take a switch as an input and in response, sends an electrical pulse to fire the gun laser.
• A micro switch molded into a rubber strap. The strap is wrapped around the trigger to secure it in place. The push button switch is positioned on the front surface of the trigger.

Acoustic Gun Assembly: This gun assembly comes in three pieces.

• A barrel anchor (you choose the gauge, 12, 20, or 28 gauge)
• A gun laser mounted in an aluminum holder
• A black electronics box, which is magnetically attached to any metal portion of your gun and because of the built-in microphone and amplifier it is capable of listening to sounds occurring inside your gun. When you pull the trigger, the loudest sound occurs when the firing pin hits a snap cap. At that moment, an electrical pulse is sent to fire the gun laser.

Combo Gun Assembly:  This gun assembly comes in five pieces.

• A barrel anchor (you choose the gauge, 12, 20, or 28 gauge)
• A gun laser mounted in an aluminum holder
• A black electronics box, which uses a switch as an input and in response, sends an electrical pulse to fire the gun laser.
• A micro switch molded into a rubber strap. The strap is wrapped around the trigger to secure it in place. The push button switch is positioned on the front surface of the trigger.
• A black electronics box, which is magnetically be attached to any metal portion of your gun and because of the built-in microphone and amplifier it is capable of listening for sounds occurring inside your gun. When you pull the trigger, the loudest sound occurs when the firing pin hits a snap cap. At that moment, an electrical pulse is sent to fire the gun laser.

Rifle/Pistol Gun Assembly: This gun assembly comes in five pieces.

• A special rifle/pistol gun clamp with; a hex wrench for adjusting, and two foam pads to prevent any damage to the gun barrel. The clamp can fit barrels from a 0.177 air rifle up to a barrlel as large as 0.850 inches. With an automatic pistol were teh barrel is covered, it can fit a maximum width of 33mm wide and 25mm deep.
• A cylindrical shaped gun laser that is attached to the gun clamp with a screw.
• A micro switch molded into a rubber strap. The strap is wrapped around the trigger to secure it in place. The push button switch is positioned on the front surface of the trigger.
• A black electronics box which supports rapid firing. The input to the box is the micro-switch, while the output is a series of electrical pulses to fire the gun laser.